Magic Power v5.3

Magic Power is used to increase the WiFi signal on a Phantom 3 standard.
The software boosts and locks the transmitting power of the WiFi.

Full instructions are here

You can download Magic Power mod for Windows HERE

You can download Magic Power mod for Apple/Mac here

18 comments

  1. Tried running this on a Mac desktop with High Sierra 10.13.1
    The Magicpower app opens, but shows no windows at all. I suspect the issue might be that WinEskin may not be up to par on High Sierra yet. WineSkin seems to be the tool the Magicpower developer use to port it to Mac from Windows.

  2. trying to install on P3 4k. firewalls off. connected to drone. keep getting access errors. Address all zeros, read address all zeros.

    1. I tried to install this on my P3S with my PC Firewall off and Step 1 went through ok, but then Step 2 failed with the following error message ‘Access Violation at addresss 000000, read of address 0000000’.
      Ive tried to run it again with both my Firewall and Anti-virus off, also Windows Defender and User Account Control off, and I added a ‘DEP Exception’ in Windows to allow the ‘magicpower.exe’ file to run without Windows supposedly interfering, but still no luck…. Can anyone help please?

        1. Hi, nope haven’t tried to run as Administrator, but my the account that I use on my PC is set as an Administrator account, so it shouldn’t matter in theory. Tho I will try it and see if it works…..Quick question….Originally Step 1 went through ok but not Step 2, should I try and ‘Run as Admin’ direct to Step 2 or start all over again with Step 1 (just anxious not to brick anything)…Any ideas?

  3. I tried to install this on my P3S with my PC Firewall off and Step 1 went through ok, but then Step 2 failed with the following error message ‘Access Violation at addresss 000000, read of address 0000000’.
    Ive tried to run it again with both my Firewall and Anti-virus off, also Windows Defender and User Account Control off, and I added a ‘DEP Exception’ in Windows to allow the ‘magicpower.exe’ file to run without Windows supposedly interfering, but still no luck…. Can anyone help please?

Leave a Reply